Problem | Possible cause |
| Solution |
|
|
| |
Time not shown in standby mode | Time not acquired | Set to major channel e.g. ZDF for | |
|
| approx.30 seconds | |
|
|
|
|
Receiver cannot be operated | Unit blocked | > | Press and hold On/standby key |
|
|
| on unit or remote control for |
|
|
| approx. 5 seconds. |
|
|
| |
Unit cannot be switched on or | Unit blocked | Perform Flash reset: Note! | |
operated |
| All personal settings will be lost. | |
|
| > | Pull out mains plug. |
|
| > | Press and hold Standby and |
|
|
| Programme up keys on the |
|
|
| unit simultaneously. |
|
| > | Keeping the Standby and |
|
|
| Programme up keys held in, |
|
|
| put mains plug back in. |
|
| > | Hold keys in for approx. |
|
|
| 5 seconds and then let them |
|
|
| go. The message “AutoInstall” |
|
|
| appears in the display. |
|
|
| |
USB device not recognised | USB device is formatted in the | Format USB device in FAT32 file | |
| wrong file system | system | |
|
|
| |
No more hard drive recordings are | Hard drive is full | Delete existing recording(s) | |
possible |
|
|
|
|
|
| |
Deleting hard drive recordings not | Damaged hard drive file system | Check hard drive (Point 8.3.5) | |
possible |
|
|
|
|
|
| |
Second encrypted programme | The two programmes selected are | Select two programmes located on | |
cannot be viewed. | not located on the same transponder | the same transponder | |
|
|
| |
| CI dual decoding is not switched on | Switch on dual decoding | |
|
| (see Point 6.5.3) | |
|
| ||
| The CI module is not compatible with Use a module with “Dual<Decrypt” | ||
| “Dual Decrypt” | compatibility |
13
91