5
>Use the green function key Accept to confirm and accept the selection, and to go to the antenna configuration
Antenna configuration
This step of the installation allows you to adjust the setting of your digital receiver to the configuration of your antenna.
>If you wish to accept the standard antenna configuration, press the green function key Accept.
In this case proceed with the point “Software update”.
>If the configuration of your reception installation does not conform to the standard setting, press the yellow function key Change.
>Carry out the antenna setting according to your receiver, as described in detail under point 6.5, and then press the red function key Back, in order to return to the antenna configuration.
>Use the green function key Accept to confirm and accept the settings, and to go to the software update.
Software updating
When you have completed making the antenna settings, the digital receiver will check whether any new version of the software for the receiver is available via satellite. If a new version is available, you can perform an automatic software update.
>Press the green function key Update.
The new software for your unit will now be downloaded. *This procedure may take a few minutes.
>If you do not wish to download the new software at this time, press the yellow function key Skip.
>If now new software is available at the present time, press the green function key
Continue.
You will then proceed to the programme search function.
Programme/channel search/ISIPRO
You have various options of searching for new channels, resp. of updating the programme list.
You can either use the ISIPRO programme list function to download a new programme list for your receiver from the satellite, or you can perform a programme scan/search.
>To download a current programme list, use the up/down arrow keys to mark the line ISIPRO programme list update.
>Confirm using the green function key Start.
The current programme list will now be downloaded from the satellite. Please note any messages displayed on screen, as well as the explanations under Point 9.5.3.
If you wish to perform a programme scan, proceed as follows:
>Use the up/down arrow keys to mark the field All programmes if you wish to search for both
>Start the scanning procedure by pressing the green function key, and an automatic programme scan will be performed.
16
