-You can also increase the speed by pressing the turbo button (A3): this function can be used at all speeds. We recommend that it is only used briefly (a maximum of 30 seconds for thick consistent doughs).

After finishing, set the speed control (A2) to “0”.

Disconnect and press the unlock button (J) to raise the hinged arm. Then press the mixer unlock button (K) to remove the mixer from its stand.

Then press the ejection button (A1) to remove the beaters or kneaders.

Blender function (according to model)

•Check that the speed control (A2) is set to “0”. •Remove the panel at the back of the appliance and screw the Blender rod (N) anti-clockwise onto the Motor Unit (A), without forcing it, until the red dots are aligned. You will hear a small click when the red dots match up indicating that the rod is correctly positioned (fig.3).

•Connect the appliance:

-Dip the Mixer rod in the preparation before starting to avoid splashing.

-Start using the speed selector (A2), (fig.2), initially at speed 1 then 2,3,4,5. Use the “Turbo” setting (A3) if the recipe requires more power.

-Stop the appliance before removing from the Blender rod (to avoid splashes).

If you feel resistance when tightening the rod it is not properly aligned. You should remove it comple- tely and re-screw correctly.

Stopping and Disconnecting the Blender rod

Select setting "0", disconnect the appliance and unscrew the Blender rod (N) by turning clockwise.

Do not use the Blender rod:

EN

•In a saucepan on the hob

•Do not use it empty or with ice cubes, sugar, hard spices, to mince raw meat, dry fruit (almonds, hazelnuts, etc.)

110

Page 113
Image 113
Tefal HT41313E manual Blender function according to model, Stopping and Disconnecting the Blender rod