6-18 Field Service
6.5.7 Display Assembly Removal/Replacement
To remove and replace the Display Assembly, use the following procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2. Remove the Keyboard Assembly as described in Paragraph 6.5.5.
3. Remove the Heat Sink Assembly as described in Paragraph 6.5.6.
4. Refer to Figure 6-12 and remove the two rear screws that secure the Display
to the notebook housing. Note: You don’t have to remove the leftmost screw.
Figure 6-12 Removing/Replacing the Display Assembly
5. Remove the screw securing the Display Cable to the Main Board and unplug
the Display Cable (CN1) and the Inverter Cable (CN8).
6. Remove the Display Assembly from the Base Assembly.
7. Replacement is the reverse of Steps 1 through 6.
Remove Rear
Display Screws
1
CN8
CN1
2Remove Display Cable
Screw And Unplug Two
Cables (CN1, CN8)