Field Service 6-33
6.6.2 Removing/Replacing the MPB Battery
To remove and replace an MPB battery pack or dummy battery pack, use the following
procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2. Using your thumbs, unlock the two battery locks at each side of the MPB
(refer to Figure 6-26).
3. Pull the module out of the MPB.
4. Installation is the reverse of Steps 1 through 3.
Figure 6-26 Installing/Removing Battery Pack in MPB
Unlocking the Battery
Battery Groove
Removing the Battery