6-26 Field Service
6.5.14 Removing/Replacing the PC Card Module
To remove and replace the PC Card Module Assembly, use the following procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2. Remove the Keyboard Assembly as described in Paragraph 6.5.5.
3. Remove the Heat Sink Assembly as described in Paragraph 6.5.6.
4. Remove the Display Assembly as described in Paragraph 6.5.7.
5. Remove the four screws that secure the PC Card Module to the Main Board
(refer to Figure 6-19).
6. Replacement is the reverse of Steps 1 through 5.
Figure 6-19 Removing/Replacing the PC Card Module
PC Module
Main Board
Assembly