6-32 Field Service
6.6 Removing/Replacing MPB FRUs

6.6.1 Removing/Replacing the Media Bay Device

To remove and replace a MPB Modular Bay Device (e.g., CD-ROM Drive or Floppy Disk
Drive), use the following procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2. Unlatch the module by pressing the latch at the base of the MPB toward the
unlock icon (rear of MPB) (refer to Figure 6-25).
3. Simultaneously, grasp the recessed grip area on the module and pull module
out of the MPB.
4. Installation is the reverse of Steps 1 through 3.
Figure 6-25 Installing/Removing Media Bay Devices
CD-ROM
Drive
Modular Bay
Release
Latch
Mobile Productivity
Base