Field Service 6-19
6.5.8 Removing/Replacing the LED/Microphone Board Assembly
To remove and replace the LED Board Assembly, use the following procedure:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack and PCMCIA cards as described in Paragraphs
6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
2. Remove the Keyboard Assembly as described in Paragraph 6.5.5.
3. Remove the Heat Sink Assembly as described in Paragraph 6.5.6.
4. Remove the Display Assembly as described in Paragraph 6.5.7.
5. Remove the two screws that secure the LED Board Assembly and unplug
cable connector CN7; remove the LED Board Assembly.
6. Replacement is the reverse of Steps 1 through 5.
Figure 6-13 Removing/Replacing the LED/Microphone Board Assembly
1Remove Keyboard
2
Remove Heat Sink
3Remove two screws
and Connector CN7
CN7