![](/images/new-backgrounds/1280311/28031169x1.webp)
SLEU063
c.Correct the problem.
d.Click OK to continue. The
Figure 20. Corrective Action Required
2.If the cable is connected from the PC parallel port to the TVP5160EVM AND the EVM power is on:
a.Click Yes.
b.The dialog shown in Figure 21 appears. This dialog appears if the PC parallel port mode setting may need to be changed.
NOTE: Only run the PC BIOS setup program if the I2C communication problem cannot be resolved in another way. (Correct slave address settings, reset or power cycle the EVM and/or check that the device type selected was TVP5160).
c.Click OK to continue.
d.The
e.Click Exit in the File menu to exit the program.
f.See troubleshooting guide above.
Figure 21. Corrective Action Required
9.2.1 Setting the PC Parallel Port Mode
NOTE: Only run the PC BIOS setup program if the I2C communication problem cannot be resolved in another way. (Correct slave address settings, reset or power cycle the EVM, and/or check that the device type selected was TVP5160).
TVP5160EVM User’s Guide | 35 |