Thermador PD30, PD36, PD48 Unpacking, Moving and Placing The Range, on Page 5. Do not remove the

Step 3: Unpacking, Moving and Placing The Range

CAUTION

Proper equipment and ad- equate manpower must be used in moving the range to avoid injury, and to avoid damage to the unit or the floor. The unit is heavy and should be handled accordingly.

Chart A	30" Range	36" Range	48" Range
Shipping Weight	335 lbs.	444 lbs.	584 lbs.
Weight without	285 lbs.	390 lbs.	524 lbs.
packing materials
Without door(s),	215 lbs.	295 lbs.	395 lbs.
burner caps, front kick
panel and oven racks

• The range has an approximate

shipping weight as shown in

ChartA.Thegrates,griddleplate

and frame, burner caps, front

kick panel and oven racks must

be removed to facilitate han-

dling. This will reduce the weight

as shown in Chart A and allow

the range to pass through 30"

doorways. See Figs. 2A and 2B

on Page 5. Do not remove the

grill or griddle assemblies.

• Remove the outer carton and

packing material from the ship-

ping base. The dual fuel ranges

are held to the skid by four (4)

bolts (see Fig. 4 and 5). After

FIG. 4 – Removal of Two Front Shipping Bolts

FIG. 5 – Removal of Two Rear Shipping Bolts

Left Rear

Shipping

Bolt

removing the bolts the range

must be lifted and removed from

the skid.

• Remove angle-mounting brack-

ets from range. This requires

the installer to remove two

screws holding each bracket

then remove bracket and rein-

stall screws.

NOTE: Leave adhesive-backed foam layer over brushed-metal sur- faces, to protect finish from scratches, until the range is in- stalled in final position.

IMPORTANT: Do not lift the range by the oven door's handle, as this may damage the door hinges and cause the door to fit incorrectly to the oven cavity.

8