Thermador PD30, PD36, PD48 Installing Anti-Tip Device, Range Tipping Hazard, Property Damage

Step 4: Installing Anti-Tip Device

For all 30" and 36" ranges, an anti-tip device must be installed as per these instructions.

WARNING

RANGE TIPPING HAZARD

•All ranges can tip and injury can result. To prevent accidental tipping of the range, attach it to the floor, wall or cabinet by installing the Anti-Tip Device supplied.

•A risk of tip-over may exist if the appliance is not installed in accordance with these instructions.

•If the range is pulled away from the wall for cleaning, service or any other reason, ensure that the Anti-Tip Device is prop- erly reengaged when the range is pushed back against the wall. In the event of abnormal usage (such as a person stand- ing, sitting, or leaning on an open door), failure to take this precaution can result in tipping of the range. Personal injury might result from spilled hot liquids or from the range itself.

WARNING

•ALL RANGES CAN TIP

•INJURY TO PER- SONS COULD RE- SULT

•INSTALL ANTI-TIP DEVICES PACKED WITH RANGE

•SEE INSTALLATION INSTRUCTIONS

WARNING

ELECTRICAL SHOCK HAZARD

•Use extreme caution when drilling holes into the wall or floor. There may be concealed electrical wires located behind the wall or under the floor.

•Identify the electrical circuits that could be affected by the installation of the Anti-Tip Device, then turn off power to these circuits.

•Failure to follow these instructions may result in electrical shock or other per- sonal injury.

ATTENTION

PROPERTY DAMAGE

•Contact a qualified installer or contractor to determine the proper method for drill- ing holes through the wall or floor material (such as ceramic tile, hardwood, etc.)

•Do not slide the range across an unpro- tected floor.

•Failure to follow these instructions may result in damage to wall or floor cover- ings.

Tools Needed for Installation of Anti-Tip Device:

• Screwdriver, Phillips	• Hammer
• Drill, electric or hand	• Pencil or other marker

•Measuring tape or ruler

•1/8" drill bit (wood or metal wall or floor)

•3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)

•3/16" anchors, drywall or concrete, 4 (not required if mounting bracket is being attached to solid wood or metal)

10