![](/images/new-backgrounds/1076794/7679427x1.webp)
COOKTOP OPERATION
•Adjust control knob to lower set- SEALED BURNERS tings in small steps.
If control | is set | too low | to | main- | Front of Burner |
tain simmer, bring the food back |
| ||||
to a boil | before | setting | a | higher |
|
simmer | setting. |
|
|
|
|
WHAT TO EXPECT
Section Four: Using the Cooktop
BURNER PLATES
f
Burner Base (C)
Indentation (E)
Notch
•The type and quantity of the food will affect which setting to use.
•Thesize, typeandmateria] ofyour pan will affect which setting to use.
When a large pan is used on a small burner, it may cause the simmer action to occur mainly in the center of the pan. When the food is stirred, the cooler food near the edges of the pan may result in an overall temperature too cool to simmer. If this hap- pens, turn the burner up slightly.
It is normal to stir food occasion- ally. This is especially important
when simmering for several hours. For example: a homemade spaghetti sauce or beans.
•It is normal not to see simmer
bubbles immediately after the food has been stirred.
SEALED BURNER
Your new cooktop features tour or
five sealed gas burners. On Mod-
els GGS30/36/365,GGSCV30/
36/365,SGS30/30Gand
SGSCV36G you have two 9,100
BTU/HR burners, two 11,000
BTU/HR burners and on the
GGSCV365 or GGS365 there is
one 6,500 BTU/HR burner. On
Models GGN30/36/365and
SGN30/36 there are two 11,000
BTU/HR and two or three 6,500
BTU/HR burners. Each burner is
sealed to the cooktop for easier cleaning.
BURNER CAPS
f
Igniter (D)
BURNER PLATE
The Burner Plate has a notch (B) on the burner base, directly across from the igniter (D). This is where the tab (A) on the burner cap fits.
NOTE: For proper burner op- eration be sure the tab (A) on the
underside of the burner cap fits
into the corresponding notch (B) on the burner plate.
GRATES
While the flame is ON there may be bubbling; there should be at least steam and a slight quivering of the liquid's surface.
•Simmer bubbles may not be seen when the flame has cycled OFF. (Models GGS & SGS)
SIGNAL LIGHT
The Signal Light (not on all models),
or "ON" Light is located in the area of the Control Knobs. For location see
"Section Three: Description", located on pages 7 to 9, to identify your model.
This light turns on when any Control Knob is set.
BURNER CAP
M,J
The Burner Cap top is porcelain enamel and has a tab (A) on the un- derside that fits into the notch (B) on the burner base (C).
f
BE SURE ALL BURNERS
ARE IN THE OFF POSI-
TION BEFORE WIPING
OR CLEANING THE
COOKTOP.
(E)
GRATE (Underside)
J
The five finger grates are porcelain enameled cast iron or steel and have
an extension (E) that is longer (un- derneath) than the other four. This extension fits into the indentation (E) on the burner plate, which is directly across from the igniter (D).
Page 12