![](/images/new-backgrounds/1076794/7679455x1.webp)
COOK'N'VENT_ VENTILATOR
See "SAFETY PRACTICES,"
on Page 4.
The efficiency of the exhaust system depends on the cleanliness of the ventilator, especially the filters. The frequency of cleaning depends on
the amount and type of cooking pre- formed.
CARE*
Scrape
Grease Off
Section Five: Care & Maintenance
Side Supports
Hook over Side
FILTERS and INTAKE
PANEL
Filters become soiled in a short pe- riod of time and should be cleaned
regularly. The filters may be cleaned by agitating them in a hot detergent
solution or by washing in the dish- washer.
Do not use the ventilating system ]
without the filters place.
TO REMOVE THE FILTERS
AND CLEAN THE PANEL
ix_'---r-
il
Raise the Vent to its
Maximum Height
. Raise the ventilator intake to its
maximum height. If the blower is on, turn it off.
Ventilator
Ca.
//, i17 Panel
. Grasp the front panel at the top
towards the sides and pull up
and forward: remove and set aside.
. Using a nylon or other
spatula, lift the accumulated
grease from the back panel - be- hind the filters. Clean front and
back panels using a mild grease solvent (See Cleaning Chart for Stainless Steel).
| after each | use. |
| J |
| TIP: Wipe | the intake off | ||
TO | REPLACE | THE | FILTERS |
|
AND | THE FRONT | PANEL |
|
Place Filters side by side
. Place the filters side by side on the support bars in front of the back panel. They will lean for- ward and the tops will rest against the inside of the front panel supports.
. Replace ventilator cap. Be cer-
tain all sides of the cap fit inside
the ventilator sides and back
panel.
Supports
. Hook the top of the front intake panel over the side supports at the top of the ventilator.
Cover and Vent Going Down
10.As the ventilator intake is low- ered, the cover will return to its position covering the ventilator.
To Clean Gap Area
Between Ventilator &
Cooktop
1.With ventilator in up position, remove front panel, ventilator cap and filters.
2.Lower ventilator completely.
3.Clean gap area using a mild
grease solvent (see Cleaning Chart).
4.Raise ventilator completely and replace filters, cap and front panel.
. | Remove | the ventilator | cap by |
|
|
|
|
| |
| grasping | both ends of the cap | . | Replace | the front panel by | hook- | |||
| and | lifting | up. |
|
| ing | the | lower front edge | of the |
|
|
|
|
|
| front panel over the lower front | |||
4. Lift | out the filters and | clean. |
| edge | of | the ventilator. |
|
* Not on all Models.
Page 26