Thermador SGS30/36G, SGSCV36G, GGSCV30/36/365, GGS30/36/365 General Care and Maintenance Cooknvent

Section Five: Care & Maintenance

GENERAL CARE AND MAINTENANCE - COOK'N'VENT

ACCESS PANELS

AND ELECTRICAL

CONNECTIONS

RemoteSIDE

BlowerVIEWS

Frequency	of cleaning depends on how		There are four different ways the Access
often the filters		and back panel at the top	Panels A and B could	have been in-
of the unit	are	cleaned.	stalled. DO NOT OPEN	ELECTRICAL
			BOX "E". See Installation	Instructions.

FRONT VIEW

	Countertop		Level
									I	m
	Below
	Counter
							®
Remote Installation									®
KEY:
A	Access	Panel				E	Electrical	Connections-		DO
B	Access	Panel					NOT OPEN (for		electrical
C	Cabinet	Blower		or	Duct		inspection only)
	Attachment		Box	for	the	F	Ventilator	Reset	Button
	Remote	Blower				G	Retainer	Bar
D	Four Thumb		Screws

Cabinet Installation

You have either a remote or a cabi- net blower C installed on the venti-

lation system of your Cook'n'Vent cooktop.

There are access panels at the base

of the ventilator system inside the cabinet. If there is a shelf under the

cooktop, it must be removable as the Access Panels A and B and the

Electrical Connection Box E must

be accessible for cleaning, electrical inspection or service.

Periodically - approximately every six months - check the enclosure

behind the access panels A and B for food soil.

TO REACH CLEAN OUT AREA

. Loosen (but do not remove) the thumb screws (Item D).

2.While holding C (it is heavy), move the retainer bar G up and lift out panels A and B. Lower the retainer bar G so it will hold C in place.

	BOX	C	J
I	O NOT REMOVE(remote BLOWERblower	installation)or DUCT. ATTACHMENT	!

3.Do not open the electrical box E on the right.

. Wipe up any accumulated grease inside the area. Wipe with a

cloth dampened with hot soapy water or use a general household spray for grease. Rinse and dry before closing the compartment.

. After cleaning, replace the access panels and securely tighten the thumb screws.

Page 27