Setting the base speaker volume | Topcom OG-T700 manual

TOPCOM OGATECH OG-T700/Twin/Triple/Quattro

If no outgoing message is recorded, a pre-recorded outgoing message will be used.

7.1.1 Setting the base speaker volume

To change the volume during playback of incoming or outgoing messages, press to increase or to decrease. The volume can be set from ‘0’-’9’. If the volume is set to the lowest position there will be no audible output during call screening and during remote interrogation, but there will be a level ‘1’ output for other operation.

7.1.2 Turning Answering Machine On/Off

If the answering machine is On, the -LED on the base will light up continuously (or blink when there are new messages) and the machine will automatically pick up the line after a number of rings ( See 7.1.3 “Setting Number of Rings” ).

If the answering machine is Off, the -LED on the base will not lit.

•Press to switch On the answering machine.

•A voice confirms the setting and playback the active OGM.

•Press to switch Off the answering machine.

Even if the answering machine is Off, it will automatically pick up after 10 rings to enable remote activation (See 7.3 “Remote Operation” )

7.1.3 Setting Number of Rings

The number of rings after which the answering machine will answer calls can be set from

2 – 9 and TS (Toll saver). The standard setting is 6 rings. In Toll saver mode, the machine will answer after 6 rings if there are no new messages, and after 2 rings if there are new messages. If there are no new messages and you call your machine to check your messages remotely ( See 7.3 “Remote Operation” ), you can hang up after the 2nd ring. You do not need to pay connection fees and you know that you do not have any new messages.

•To check the actual number of rings, briefly press the ‘skip forward’ button. A voice will playback the current number of rings.

•Press for 2 secs to set the number of ringing tones.

•Press immediately to change the current number of rings.

•If you do not press any keys for 3 seconds, the machine will set the selected number of rings.

7.1.4 Day and time setting

•Press and hold the -key until the day is pronounced.

•Press the or to change the day and press the -key to confirm and go to the hour settings

•Press the or to change the hours and press the -key to confirm and go to the minutes settings

•Press the or to change the minutes and press the -key to confirm

If the day and time are correctly entered, the unit will anounce the new setting.

ENGLISH