Toshiba 1600XP operation manual Fierr, Out

1600XP Series Installation and Operation Manual

B-3

1600XP Command Parameters Table

Cmd	Description	Brief Description	Location Map		Example	Rqd Security	By
ID	on LCD					Level to change
			Tab	Block
119	VIOV DeLevel	Input Overvoltage Detection Level	Setting	IN	274 V	Nonchangeable	User
		- Of rated input voltage which was configured				Nonchangeable	Administrator
		with Command ID 111.				Changeable	Service
120	VIOV ReLevel	Input Overvoltage Recovery Level - Of rated	Setting	IN	264 V	Nonchangeable	User
		input voltage which was configured with Com-				Nonchangeable	Administrator
		mand ID 111.
121	Vin Gain	Used to convert AD value to actual value	Setting	IN	6720	Changeable	Service
122	Vin Offset	Feedback Offset adjustment due to hardware	Setting	IN	0	Changeable	Service
		and software AD converter’s offset
124	Iin Gain	Used to convert AD value to actual value	Setting	IN	5241	Changeable	Service
125	Iin Offset	Feedback Offset adjustment due to hardware	Settings	IN	0	Changeable	Service
		and software AD converter’s offset.
127	Iin 100%	100% Input Current Amount	Settings	IN	250	Changeable	Service
128	Iref Phase Adj	Time delay adjustment to sync the phase of	Settings	IN	17500	Changeable	Service
		input voltage and current due to hardware and
		software delay.
141	Freq on	Freq setup on input frequency error	Setting	IN	60.0 Hz	Nonchangeable	User
	FIERR*	- Toshiba UPS try to detect input frequency but				Changeable	Administrator
		very tiny percentage when UPS can not detect				Changeable	Service
		the input frequency because of fluctuation,
		1600XP UPS will start by using this setup.
202	No of Output	No of Output Lines	Setting	OUT	1 Line	Nonchangeable	User
	Line	- Always 1 input line for 1600XP series				Nonchangeable	Administrator
						Changeable	Service
215	Rated Vout*	Rated Output Voltage	Setting	OUT	240 V	Nonchangeable	User
		- Must be setup properly at initial startup.				Changeable	Administrator
		Rated output voltage is used to calculate per-				Changeable	Service
		centages for ID 220, 222
216	Rated Iout	Rated Output Current	Monitor	OUT	25.0 A	Nonchangeable	User
		- UPS calculated rated output current from				Nonchangeable	Administrator
		typeform command id 002.				Changeable	Service
220	VOUV De-	Output Undervoltage Detection Level in Per-	Setting	OUT	90 %	Nonchangeable	User
	Level*	centage				Nonchangeable	Administrator
		- Of rated output voltage which was configured				Changeable	Service
		with Command ID 215.