10- 1
10. REMOVING JAMMED MEDIA In the event of a media jam inside the printer, use the following procedures to clear it:
Please be careful not to get your fingers caught in the covers while opening
or closing them. This may cause injuries.
10.1 Removing Jammed Media from the Cutter Unit
This section describes how to clear a “Cut failed” message.
1. Turn the Power Switch off. Open the Front Cover, Side Cover, and Upper Unit.
2. Slide the Cutter Carriage either rightward or leftward until it comes to the end.
3. Remove the jammed media from the Cutter Unit.
4. Reload the media properly. Close the Upper Unit, Front Cover, and Side Cover.
CAUTION
Cutter Carriage