Toshiba CEILING TYPE Push SET + CL + Test buttons, Simultaneously for 4 seconds or more, Button

9-3. Address Setup (Manual Setting from Remote Controller)

In case that addresses of the indoor units will be determined prior to piping work after wiring work

•Set an indoor unit per a remote controller.

•Turn on power supply.

(Example of 2-lines wiring)

(Real line: Wiring, Broken line: Refrigerant pipe)

Outdoor			Outdoor
1	2	3	1	2	3

	1	2	3
	Indoor
	A B
	Line address → 1
	Indoor unit address → 1
1 Push SET + CL + TEST buttons	Group address → 1
	A B

simultaneously for 4 seconds or more.

1 2 3

Indoor

A B

1

2

2

1 2 3

Indoor

A B

1

3

2

1 2 3

Indoor

A B

2

1

2

1 2 3

Indoor

A B

2

2

2

2 (Line address)

Using the temperature setup / buttons, set 12 to the CODE No.

Remote controller

For the above example, perform setting by connecting singly the wired remote controller without remote controller inter-unit wire.

3						Group address
	Using timer time	/	buttons, set the line address.			Individual	: 0000
						Header unit	: 0001	In case of group control
4						Follower unit : 0002
	Push SET button. (OK when display goes on.)
5	(Indoor unit address)			/	buttons, set 13 to the CODE No.
	Using the temperature setup
6	Using timer time	/	buttons, set 1 to the line address.
7	Push SET button. (OK when display goes on.)
8	(Group address)			/	buttons, set 14 to the CODE No.
	Using the temperature setup

9 Using timer time / buttons, set 0000 to Individual, 0001 to Header unit, and 0002 to

Folloer unit.

10 Push

11 Push

SET

TEST

button. (OK when display goes on.)

button.

Setup completes. (The status returns to the usual stop status.)

TEMP. ON / OFF

2, 5, 8

END 11

1

<Operation procedure>

	TIMER SET
	TIME
FILTER	SET CL
RESET TEST

FANMODE

SAVEVENT

SWING/FIX UNIT LOUVER

3, 6, 9 4, 7, 10

1 2 3 4 5 6 7 8 9 10 11 END

– 86 –