Toshiba CEILING TYPE, CONCEALED DUCK TYPE service manual Setup AT Local

No.	Item		Outline of specifications	Remarks
18	DC motor	1)	When the fan operation has started, positioning of
			the stator and the rotor are performed.
			(Moves slightly with tap sound)
		2)	The motor operates according to the command from
			the indoor controller.

Notes)

•When the fan rotates while the air conditioner stops due to entering of outside air, etc, the air conditioner may operate while the fan motor stops.

		• When a fan lock is found, the air conditioner stops, and								Check code [P12]
		an error is displayed.
19	Self-clean	1)	When cooling operation mode (AUTO COOL, COOL, DRY) stopped, the following
	operation		three self-clean operations are performed.
	(Dry operation)
			Compressor		Self-clean		FAN		Drain pump		Louver
			ON period		operation period
			0 to 10 min.		None						Horizontal discharge
			10 to 60 min.		1 hour		Fan (UL)		STOP
											position
			60 min. to		2 hours						∗Concealed duct is none.
		2)	During operation of self-clean,			lights on the wired				And it is not also on the
			remote controller screen. However the operation							wireless remote controller.
			lamp (Green LED) goes off.							It is recognized as [STOP]
		3)	To stop the self-clean operation, push twice the							from the remote monitor
			[ON/OFF] button on the remote controller							side.
			continuously. (Stop the operation as compressor ON
			time in the table above: 10 minutes or below.)
		4)	When the follower unit executes self-clean operation
			in the group connection, the segment of					is
			displayed on the wired remote controller screen via
			master unit.
			∗ If self-clean operation is not used, set invalidity
			(does not use) of the self-clean operation by
			changing [0001 (At shipment) of CODE No. (DN)
			[D3] to [0000].
			∗ To erase the		display during operation of
			self-clean, change CODE No. [D4] from [0000:
			Display (At shipment)] to [0001: Non-display].
20	Save operation	1)	Turn on SAVE	button on the remote controller.						Carry out setting
		2)	During operation of save operation,				lights on the			operation during stop of
			wired remote controller.							the unit; otherwise the
		3)	During save operation, the current release control is							unit stops operation.
										For the setup operation,
			performed with the restriction ratio set in EEPROM
										refer to
			on the outdoor unit.
										“How to set contents of
		4)	The restriction ratio can be set by keeping					SAVE
										save operation” in Sction
			button pushed for 4 seconds or more on the remote
										“8. SETUP AT LOCAL
			controller.
										SITE AND OTHERS”.
		5)	When validating the save operation, the next opera-
			tion starts with save operation valid because contents
			are held even when operation stops, operation mode
			changes or power supply is reset.
		6)	The restriction ratio can be set by changing the setup
			data of CODE No. (DN) [C2] in the range of 50 to
			100% (every 1%, Setting at shipment: 75%).

– 38 –