Auto clock setting / Setting the video channel

Auto clock setting

NOTES:

¥When shipped from factory, the video channel is set to CH 3.

¥If the unit does not operate prop- erly, or there is no key operation from the unit and/or the remote control: Static electricity, etc., may affect the operation. Disconnect the AC power cord once, then con- nect it again.

Preparation:

You must connect the antenna or cable before connecting the AC cord to the power source.

After the antenna or cable is connected, wait for at least 3 minutes with

Introduction

 

the power turned off for the auto clock feature to activate.

 

After the clock is set automatically, you may have to set the Standard

 

Time (time zone) and Daylight Saving Time. (See 27.)

 

Press ON/STANDBY to turn on the DVD/VCR after the auto clock op-

 

eration completed.

 

¥When shipped from factory, the ÒAUTO CLOCKÓ option is set to ÒONÓ position.

¥If you turn the DVD/VCR on during auto clock setting, the clock is not set.

¥Depending on the reception condition, auto clock setting may take approx. 30 minutes.

¥After a power failure or disconnection of the power plug, the clock will be lost. In this case, wait 3 minutes before turning the DVD/VCR on.

¥With cable box connection, if the auto clock setting is unsuccessful, select the PBS channel carrying the XDS information, then turn the DVD/VCR off. After 3 minutes, turn the DVD/VCR on.

¥If the clock is not set automatically, set the clock manually. (See page 27.)

Setting the video channel

To view playback of a recorded tape or DVD disc, or to watch a program selected by the VCR’s channel selector, the TV must be set to channel 3 or 4 (video channel).

When a TV is connected with the 75 ohm coaxial cable only:

1Press and hold 3 or 4 on the remote control for 3 seconds in the standby mode to select CH 3 or 4. The selected channel number will flash on the display for about 4 seconds.

2Turn ON the TV and set to CH 3 or 4 to correspond with the chan- nel selected in step 1.

3Press ON/STANDBY to turn on the DVD/VCR.

4Press TV/VIDEO to select the VIDEO position. The TV indicator will disappear in the display.

5Select any channel to receive a TV station in your area.

The channel number will appear on the screen for about 4 sec- onds.

For a push-button TV tuner

If CH 3 or 4 corresponding to the video channel cannot be tuned on your TV, proceed as follows: set the VCR 3/4 channel selector and the TV to CH 3 or 4, playback a prerecorded tape and tune the TV to re- ceive a sharp color picture from the video cassette recorder. Refer to your TV ownerÕs manual for details.

23

2J40101A P23-33

23

3/4/06, 10:43 AM

Page 23
Image 23
Toshiba D-VR5SU owner manual Auto clock setting / Setting the video channel, Preparation