Toshiba DEV002Z-1 manual Instance 21/71 DeviceNet Standard 4 bytes, parameter f830 =

									E6581281 f
3.4.5.2. Instance 21/71 - DeviceNet Standard (4 bytes, parameter f830 = 1)
Byte	Bit 7	Bit 6	Bit 5	Bit 4		Bit 3	Bit 2	Bit 1		Bit 0
0	-	Net Ref *	Net Ctrl *	-		-	Fault reset	Run		Run
								reverse		forward
1
					-
2			Drive Reference Speed min-1(Low byte)
3			Drive Reference Speed min-1(High byte)
			Fig. 3 Output Instance 21 Layout
Byte	Bit 7	Bit 6	Bit 5	Bit 4		Bit 3	Bit 2	Bit 1		Bit 0
0	At	Ref from	Ctrl from	Ready		Running	Running	Warning		Faulted/
	reference **	Net **	Net **			Reverse	Forward			tripped
1
				Drive Status ***
2			Drive Reference Speed min-1(Low byte)
3			Drive Reference Speed min-1(High byte)

Fig. 4 Input Instance 71 Layout

* Bit 5 and 6 of the instance 21 byte 0 are defined as follows.

Bit 5 (Net Ctrl)		When “1” is set, bits 0 (Run forward) and 1 (Run reverse) of byte 0 are enabled.
		When “0” is set, Run/Stop is according to setup of the parameter cmod.
Bit 6 (Net Ref)		When “1” is set, bytes 2 and 3 are enabled. When “0” is set, Drive Reference
		Speed is according to setup of the parameter fmod.
** Bit 5, 6, and 7 of the instance 71 byte 0 are defined as follows.
Bit 5	(Ctrl from Net)......... When RUN/STOP command from DeviceNet is enabled, “1” is set.
Bit 6	(Ref from Net)......... When frequency command from DeviceNet is enabled, “1” is set.
Bit 7	(At reference) ......... When output frequency becomes the same as frequency command, “1” is set.

***Drive Status is same as the Control Supervisor class State attribute (refer to section 3.7.2). 1 (= BN: 00000001): Startup

2 (= BN: 00000010): Not Ready

3 (= BN: 00000011): Ready

4 (= BN: 00000100): Enabled

5 (= BN: 00000101): Stopping

6 (= BN: 00000110): Fault Stop

7 (= BN: 00000111): Faulted

- 14 -