Toshiba GA-1121 manual With Expert Mode, you can print a Comparison Page see

22-28 Color Calibration

4.For Calibration Mode, choose Standard or Expert, and press Set.

With Expert Mode, you can print a Comparison Page (see page 2-7).

5.For Measurement Method, choose AutoCal or ColorCal, and press Set.

6.For Tray, choose the paper source for the patch page and press Set.

Choose LTR/A4 from the GA-1121 Control Panel.

NOTE: If you print a measurement page from the Manual Feed tray, you must load the appropriate paper in the tray and select the correct paper size from the copier/printer touch panel display.

7.Choose Calibrate, and press Set.

8.Select the Media and press Set.

Choose from the list of all calibration sets on the GA-1121. This prompt appears only if more than one calibration set is available.

9.When prompted, choose Yes to print the measurement page.

This page is comprised of swatches of color that will be measured by the copier/printer’s scanner and then compared to the target color values. After the page is printed, the Measure Page screen appears.

10.Choose Yes in the Measure Page screen.

11.When prompted on the Control Panel, place the Kodak Gray Scale strip face-down on the copier/printer glass.

Place the strip along the top edge of the copier/printer so that it is centered between the paper width marks on the copier/printer.

Place grayscale strip face down	Place color measurement page face
	down over grayscale strip