360050398
10.8.31.2 Set Max Set Password
F9h with the content of the Features register equal to 01h.
COMMAND CODE |
| 1 1 1 1 1 0 0 1 | REGISTER | |
| REGISTER SETTING | NORMAL COMPLETION | ||
DR |
| DRIVE No. | no change | |
CY |
|
|
| no change |
HD |
|
|
| no change |
SN |
|
|
| no change |
SC |
|
|
| no change |
FT |
|
| 01 H | no change |
LBA |
|
|
| no change |
This command is not immediately preceded by a READ NATIVE MAX ADDRESS command. If this command is immediately preceded by a READ NATIVE MAX ADDRESS command, it shall be interpreted as a SET MAX ADDRESS command.
This command requests a transfer of a single sector of data from the host. Table
Table
Word | Content |
0 | Reserved |
Password (32 bytes) | |
Reserved |
10.8.31.3 Set Max Lock
F9h with the content of the Features register equal to 02h.
COMMAND CODE |
| 1 1 1 1 1 0 0 1 | REGISTER | |
| REGISTER SETTING | NORMAL COMPLETION | ||
DR |
| DRIVE No. | no change | |
CY |
|
|
| no change |
HD |
|
|
| no change |
SN |
|
|
| no change |
SC |
|
|
| no change |
FT |
|
| 02 H | no change |
LBA |
|
|
| no change |
This command is not immediately preceded by a READ NATIVE MAX ADDRESS command. If this command is immediately preceded by a READ NATIVE MAX ADDRESS command, it shall be interpreted as a SET MAX ADDRESS command.
The SET MAX LOCK command sets the device into Set_Max_Locked state. After this command is completed any other SET MAX commands except SET MAX UNLOCK and SET MAX FREEZE LOCK are rejected. The device remains in this state until a power cycle or the acceptance of a SET MAX UNLOCK or SET MAX FREEZE LOCK command.
Toshiba Corporation Digital Media Network Company
Page 94 of 157
© 2005, Copyright TOSHIBA Corporation All Rights Reserved