Manuals / Toshiba / Household Appliance / Air Conditioner

Toshiba RAV-SM804BT-TR, RAV-SM454MUT-E, RAV-SM804BT-E 35, Item, Outline of specifications, Remarks

Models: RAV-SM454MUT-TR RAV-SM564CT-E RAV-SM564BT-E RAV-SM564MUT-E RAV-SM564BT-TR RAV-SM564MUT-TR RAV-SM804BT-TR RAV-SM804BT-E RAV-SM1104BT-TR RAV-SM1404BT-TR RAV-SM1104BT-E RAV-SM1404BT-E RAV-SM404MUT-TR RAV-SM454MUT-E

1 120

Download 120 pages 15 Kb

Page 35

<In case of wired remote controller>

No.	Item		Outline of specifications	Remarks

13	Frequency	<In case of wired remote controller>		Command frequency is
	fixed operation	1)	When pushing [CHK] button for 4 seconds or more, [TEST] is	approximately [S7]
	(Test run)	1)	When pushing [CHK] button for 4 seconds or more, [TEST] is
	(Test run)		displayed on the display screen and the mode enters in Test
			run mode.
		2)	Push [ON/OFF] button.
		3)	Using [MODE] button, set the mode to [COOL] or [HEAT].
			• Do not use other mode than [COOL]/[HEAT] mode.
			• During test run operation, the temperature cannot be ad-
			justed.
			• An error is detected as usual.
			• A frequency fixed operation is performed.
		4)	After the test run, push [ON/OFF] button to stop the operation.
			(Display in the display part is same as the procedure in Item 1.)
		5)	Push [CHK] button to clear the test run mode.
			([TEST] display in the display part disappears and the status
			returns to the normal stop status.)

<In case of wireless remote controller> (Compact 4-way, Concealed Duct type)

1)Turn off power of the set.

Remove the nameplate of the receiver unit and then turn the Dip switch to [Test operation / ON].

2)The test operation starts by [START/STOP] button.

•[START], [TIMER] and [READY] LEDs flash during test operation

•Under condition of [Test operation / ON], the temperature adjustment is invalid even if using the wireless remote controller. Do not use it at other cases than a test operation because it applies excessive force.

3)Carry out a test operation under anyone mode of HEAT, COOL or FAN operation mode.

•The outdoor unit does not operate for approx. 3 minutes after the power supply was turned on and after operation stop.

4)After the test operation, stop the unit by the wireless remote controller and then return Dip switch of the receiver unit to the original position.

(In order to prevent sequential test operation, this receiving unit is attached with 60-minutes timer release function.)

Receiver unit

Spacer

M4 × 25 screw (2 pieces)

Notch Nameplate

Small screw

– 35 –

Image 35

Toshiba RAV-SM804BT-TR, RAV-SM454MUT-E 35, Item, Outline of specifications, Remarks, <In case of wired remote controller>

Contents

INDOOR UNIT <DIGITAL INVERTER> SERVICE MANUAL SPLIT TYPER410A CONTENTS 6. TROUBLESHOOTING – 4 – Original instructionGeneric Denomination: Air Conditioner Indication – 5 –Work undertaken Protective gear wornWarning indication Warning Indications on the Air Conditioner UnitBURST HAZARD – 6 –– 7 – Precaution for SafetyDENGER – 8 – – 9 – – 10 – – 11 – Explanations given to userRelocation Declaration of ConformitySpecifications 2Joint New Refrigerant R410A1 Copper pipe <Piping> Flare nut– 14 – 4.ToolsGeneral tools Conventional tools can be used – 15 – 1-1.Static Pressure Characteristics1. AIR DUCTING WORK Concealed Duct typeFig. 8 SM140 type Square duct Fig. 5 SM110 type Round ductFig. 7 SM140 type Round duct Fig. 6 SM110 type Square duct– 17 – Space required for installation and servicing2. CONSTRUCTION VIEWS EXTERNAL VIEWS 2-1.Compact 4-wayCassette TypeSM110 type – 18 –SM56 type SM80 typeØ12.7 – 19 –Model name SM56 type– 20 – 3. WIRING DIAGRAM3-1.Indoor Unit 3-1-1.Compact 4-wayCassette Type– 21 – 3-1-2.Concealed Duct Type– 22 – 3-1-3.Ceiling Type– 23 – SpecificationsSpecifications SpecificationsIndoor unit Wired Simple heder remote controller Max. 2 unitsCentral remote controller – 24 –∗ “1:1 model” connection interface Option Wireless remote controller– 25 – Indoor unit #1 Heder– 26 – Wireless remote controllerWired Simple heder remote controller Central remote controllerRemarks 5-2.Control SpecificationsOutline of specifications ItemRemarks Outline of specifications– 28 – ItemRemarks Outline of specifications– 29 – ItemCeiling type – 30 –Item RemarksRemarks Outline of specifications– 31 – ItemItem Outline of specificationsSetup at shipment – 32 –Remarks Outline of specifications– 33 – ItemItem Outline of specificationsAlarm – 34 –Item Outline of specifications<In case of wired remote controller> – 35 –Item Outline of specifications4, 5, – 36 –Remarks Outline of specifications– 37 – ItemItem Outline of specifications“8. SETUP AT LOCAL – 38 –Remarks Outline of specifications– 40 – 5-3.Indoor Print Circuit BoardFunction ConnectorSpecifications – 41 –Confirmation of check code display <Wired remote controller type>– 42 – TroubleCheck defective position and parts When wireless remote controller is connectedTrouble Confirmation of lamp display– 44 – Outline of judgmentCheck code – 45 –Lamp indication Check code Others Other than Check Code– 46 – Lamp indication6-2.Check Code List Indoor Judgment and measures Error mode detected by indoor unitOperation of diagnostic function – 48 –– 49 – Error mode detected by outdoor unitStatus of Operation of diagnostic function– 50 – CheckPage – 52 – Check code E01 errorE09 error E10 error E04 error– 54 – E18 errorE08, L03, L07, L08 error L09 error– 55 – L20 errorL30 error P30 error Central controllerF10 error P10 error– 57 – P12 error– 58 – P19 errorCheck by tester – 59 – F02 errorF01 error – 60 – C06 error 1:1 model connection interface– 61 – E03 error Master indoor unitF29 error P31 error Follower indoor unitResistance value kΩ TA, TC, TCJ, TE, TS, TO sensorTA, TC, TCJ, TE,TS, TO sensor TD, TL sensor– 63 – Winding Resistance of Fan MotorPage CODE No. required at least 1 Setting data read out from EEPROMContents – 65 –– 66 – <Fig. 2 EEPROM layout diagram>3 6 5 MCC-1402Table Setting dataSetting data Setting data– 68 – 8-1-1.Test Run Setup on Remote ControllerWired remote controller 8-1.Indoor Unit– 69 – Procedure4, 5, <Ceiling Type>8-1-3.LED Display on Indoor P.C. Board 1.D002 Red 3 4 5Preparation in advance Practical operation– 71 – 8-1-4.Function Selection Setup4 5 2 1 2 3 4 5 6 ENDAt shipment – 72 –Item No. DN table Selection of function DescriptionAt shipment – 73 –Item Description– 74 – <Wired remote controller><Wireless remote controller> Wireless remote controller– 75 – 8-1-6.Monitor Function of Remote ControllernCalling of sensor temperature display 1 2– 76 – REQUIREMENT– 77 – nIndoor unit power-ONsequence– 78 – 8-2.Setup at Local Site / Others5.P.C. Board Switch SW01 Setup 4.Wiring Specifications– 80 – <Procedure> Perform setup while the unit stops1 2 3 3 1 4– 81 – – 82 – 9-1.Address Setup– 83 – 9-2-1.System configurationExample – 84 –Change is necessary simultaneously from the remote controller– 85 – 1 2 3 4 5 6 7 8 9 10 11 END 3, 6, 9 4, 7,1 2 END 2.Attachment 10-1.Compact 4-WayCassette Type1. Detachment 1. Detachment Procedure1. Detachment 2.Attachment2.Attachment Procedure– 90 – 1. Detachment2.Attachment Procedure– 91 – 1.Detachment2.Attachment Procedure– 92 – 1.Detachment2. Attachment Procedure– 93 – 1. Detachment2. Attachment Procedure– 94 – 9Fan motor 1. Detachment2. Attachment Procedure– 95 – 10Drain pan 1. Detachment– 96 – Procedure1 Recover refrigerant gas <Details of sensor lead wire drawing>Part name Procedure10-2.Concealed Duct Type – 97 –Remarks Procedure– 98 – Part nameRemarks Procedure– 99 – Part nameNo. Part name Procedure10-3.Ceiling Type – 100 –Remarks Procedure– 101 – Part nameRemarks Procedure– 102 – Part nameRemarks Procedure103 Part name– 104 – 11-1.Compact 4-wayCassette TypeDescription 105Location Part NoDescription – 106 –Location Part NoModel name Electric parts– 107 – Location204, 206, 11-2.Concealed Duct Type240 241 242 229 216 227 203, 902,Description 109Location Part No– 110 – 230 221 228 229 219 202 203235901, 902, 903 222 223 220 232 234 224 218 212Model name – 111 –Location Description215 214 213 212 230, 232 223211 237221 202 203, 901, 902, 903 224 236 225 222 234Description – 113 –Location Part NoModel name RAV-SM Electric parts– 114 – Location11-3.Ceiling Type Model name RAV-SM – 116 –Part No DescriptionModel name RAV-SM – 117 –Part No DescriptionModel name Electric parts– 118 – LocationCheck of Concentration Limit WARNINGS ON REFRIGERANT LEAKAGETOSHIBA CARRIER CORPORATION