Toshiba RD-XS35SU Preparation of the remote control, Open the cover Insert batteries AAA size

Introduction

Preparation of the remote control

1 Open the cover.

2 Insert batteries (AAA size).

Make sure to match the + and – on the batteries to the marks inside the battery compartment.

3 Close the cover.

Caution

•Never throw batteries into a fire.

Notes

•Be sure to use AAA size batteries.

•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.

•When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.

•Always remove batteries from the remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

30° 30°

Within about 7 m (23 ft)

Distance : About 7 m (23 ft) from the front of the remote sensor

Angle : About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the recorder to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the recorder via the remote control.

Notes

•Do not drop or give the remote control a shock.

•Do not leave the remote control near an extremely hot or humid place.

•Do not spill water or put anything wet on the remote control.

•Do not disassemble the remote control.

18

RD-XS35SU/SC_Inst_E_p02-18 18 06.2.13, 4:33 PM