Toshiba RD-XS35SU owner manual Startup/finishing closing icons, If a message appears

Turning the power off

Press ON/STANDBY button from the remote control or on the front panel of the recorder.

The “Unloading” icon appears on the right corner of the top of the screen, and the ON/STANDBY indicator turns red. Then the power turns off.

Note

•If the recorder freezes for about 15 minutes and will not respond to any buttons, holding down ON/STANDBY button on the front panel for about 10 seconds can force the recorder to turn off. However, this is an emergency measure, which contains a risk of damage to data or discs. Avoid casual use of this measure. If you try this while the recorder is operating properly, especially while the “Loading” or “Unloading” icon is flashing, it may result in re- initialization of the HDD.

Startup/finishing (closing) icons

These icons are displayed on the right corner on the top of the screen. While they are flashing, the recorder is operating as follows:

If a message appears

The recorder may display a message. Each message varies according to operational status.

To respond, follow the examples below.

Message

e.g.

		message
		OK
		Set
e.g.		Select either response (by
		highlighting in green) using
message		/ buttons, then press
		ENTER button.
YesOK	No	The message disappears.

Introduction

Connections

Startup, reading a disc, finishing recording

Loading

Unloading a disc, finishing the recorder’s

Un operation loading

Opening a disc tray

Open

Closing a disc tray

Close

2 selections

e.g.

message

OK

1 selection

Read the message, then press ENTER button.

The message disappears.

Basic setup

e.g.		The message disappears
	message	automatically in a few seconds.

No selection

31

RD-XS35SU/SC_Inst_E_p29-43 31 06.2.13, 4:33 PM