About lamp
The product’s light source is a mercury lamp that lights at increased internal pressure. Be sure to fully understand the following characteristics of the lamp and handle it with extreme care.
• The lamp may burst with a loud noise due to impact or deterioration, or fail to light at |
the expiration of its life. |
• How long it takes before the lamp bursts or the life expires may vary greatly by lamp. |
Some may burst shortly after first use. |
Lamp replacement (Continued)
1Unplug power cord.
2Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
• Burst is likely to happen if the lamp is used after the replacement period has elapsed. |
• When the lamp bursts, the broken pieces of glass may get inside the product or be |
released outside from the openings for ventilation. |
• When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with |
glass dust may be released from the openings for ventilation. |
3 Remove the outer lamp cover. | 3 |
Loosen the two screws, raise the outer lamp cover with your fingers as shown to remove the outer lamp cover. Use care to avoid any damage to nails and/or tip of your finger(s). If
1
Outer lamp cover
■ Immediately replace the lamp when a sign appears on the screen. |
• When the replacement time approaches, a message will appear on the screen. |
• The risk of burst will increase if the lamp is continuously used without being replaced. |
• Frequently check the used hours and prepare spares when the replacement time |
approaches. (Refer to “Status display”. p.48 ) |
■ When the lamp is broken |
you have any difficulty in removal, you can use a screwdriver or any other smaller tool for your convenience.
2
• If glass components, including a lamp and a lens, should break, handle the broken |
pieces with care to avoid injury and contact your dealer for repair service. |
• In the event of lamp burst, unplug the product from the wall outlet, leave and completely |
ventilate the room. Then, thoroughly clean the area around the projector and discard |
any edible items placed in that area. |
• When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes |
or you breathe it. |
Lamp replacement
A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on condition of use.) If this happens, replace it with a new one.
WARNING
•If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer- ship when the lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger of damage from falling pieces of glass if the lamp is broken. Besides, working at high elevations can also be hazardous. Do not attempt to replace the lamp by yourself.
•When replacing, always use lamp “TLPLW14” (sold separately).
CAUTION
•If you have been using the projector, the lamp will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
•If the lamp should break, please handle with care to avoid injury due to broken pieces and contact your dealer for repair service.
4 Remove the inner lamp cover. | 4 |
Loosen the screw to remove the inner lamp cover.
5 Pull out the lamp. | 5 |
Loosen the three lamp locking screws, pull up the handle, and press the tab to remove the lamp.
6 Mount the new lamp. | 6 |
Align the orientation, press down the new lamp until the bottom is reached, and lock in place using the three lamp locking screws.
1
2 
Inner lamp cover
1 | Tab | Maintenance |
| ||
|
|
2 
2
1
80 | 81 |
