Screen combination of PIP and SPLIT functions, Operations

Using handy features (Continued)

■Screen combination of PIP and SPLIT functions

Group

Input signal

AComputer 1 (Digital) / Y/PB/PR 1 (Digital) Computer 1 (Analog) / Y/PB/PR 1 (Analog) Computer 2 / Y/PB/PR 2

Computer 3 / Y/PB/PR 3 Wireless/Card

USB memory

BVideo S-video

For PIP function

A:	Main screen,	B:	Sub screen
A:	Sub screen,	B:	Main screen

You cannot display two screens of the same group in the PIP mode.

For SPLIT function

A, B or B, A is available.

You cannot display two screens of the same group in the SPLIT mode.

■Password function

When the password function is added and [Password] is set to [On], image projection requires an entry of the preset password at power-on.

To add the password function, perform the following procedure:

(The password function, once added, cannot be deleted. Set [Password] to [Off] if you do not want to use it after addition.)

Note: This password is different from that used for the wireless LAN.

1Set the projector to the operating status or the standby mode.

2Keep pressing the button for about 10 seconds until a beep sounds.

The password function is added when the steps up to here have been completed. It is also added to the Default setting menu.

How to set password (from [Off] to [On])

1Select [Password] in the Default setting menu and press theor button.

The password setting confirmation screen is displayed. ([OK] or [Cancel])

2Select [OK] and press thebutton.

The password entry screen is displayed.

3Enter a four-digit number for the password using numeric keys of the remote control.

The input number appears as [****].

4Re-enter the same password for confirmation.

When the password is confirmed, the setting is complete and the password becomes [On].

If the password is wrong, repeat the procedure from step 2 .

How to operate when password is [On]

1Turn on the power.

2The lamp lights and the password entry screen appears.

3Enter the password using numeric keys of the remote control.

If the entered password is correct, the start-up screen appears and the projector goes into normal operation. If the password is wrong, a message appears to prompt you to re-enter the password. If you enter a wrong password for more than 5 times, the projector will automatically power off and enter standby mode.

How to cancel password (from [On] to [Off])

1Select [Password] in the Default setting menu and press the or button.