Setting up the wireless LAN (Continued)
■Caution when using the wireless LAN functions
The Wireless LAN in this unit uses the 2.4 GHz waveband. If there is a similar wireless LAN in the area, or a wireless device using the 2.4 GHz waveband, or a microwave oven, the communication efficiency of this apparatus will be reduced, and may become unusable, but it is not a fault. If this happens, check an area away from the current location that will not cause radio interference to medical, industrial and public equip- ment, and change to it, or stop using the unit.
■Setup using the Setting display (2)
●Projector settings (Be sure to read this subsection.)
Using the factory settings
1. Press the MENU button twice The Setting display (2) is displayed.
* Appears only when Wireless/Card or USB memory input.
2. Select a Category
Select a category by using 
.
The following three categories are available:
Wireless utility p.54 setup
Slide Show setup p.60
Displays the current settings of selected category.
Item shown with gray cannot be set with the currently selected input source.
Status display p.65
3.Make settings Press 
or 
to open the menu.
Item
These marks signify the items can be
selected from the list by using 
. After an item is selected, apply it by
pressing 
.
The figure shows a typical example. As the display may differ depending on the item, use the following pages as a reference.
4. Back | RETURN button |
5. End | Press the MENU button or RETURN button. |
| (The menu disappears 30 seconds after the last operation.) |
Note
•When the item (2) of the Setting display menu is set or when the setting window disappears after the settings are changed, the message “Saving...” appears on the screen. Be sure not to turn the projector power off or unplug the power cord in such a case.
Operations
52 | 53 |
