TMP92CM22 2007-02-16 92CM22-192
(1) Serial Clock
1. Clock source
SBI0CR1<SCK2:0> is used to select the following functions:
Internal clock
In internal clock mode one of seven frequencies can be selected. The serial clock
signal is output to the outside on the SCK pin.
When the device is writing (in transmit mode) or reading (in receive mode), data
cannot follow the serial clock rate, so an automatic wait function is executed
which automatically stops the serial clock and holds the next shift operation until
reading or writing has been completed.
Figure 3.10.22 Automatic Wait Function
External clock (<SCK2:0> = “111”)
An external clock input via the SCK pin is used as the serial clock. In order to
ensure the integrity of shift operations, both the high and low-level serial clock
pulse widths shown below must be maintained. The maximum data transfer
frequency is 1.25 MHz (when fSYS = 20 MHz).
Figure 3.10.23 Maximum Data Transfer Frequency when External Clock Input
a0
3
SCK pin output 1 2 78 21 6 7 8 1 2 3
SO pin output a1 a5
a2a6a7b0b4
b1b5b6b7 c0 c1 c2
Writing
transmission
data
a b c
Automatic wait
tSCKL
SCK pin
tSCKL and tSCKH > 8 fSYS
tSCKH