Toshiba TLP-MT7E manual Connect the power cord, Take off the lens cover, Power cord Supplied

18

connectionInstallation and

Floor-mounted projector placement (continued)

3	Connect the power cord.
	• Insert one end in the AC IN socket on the projector.
	• Insert the other end in a wall outlet.
						KEY ASUTOT O
						N E	A
							SEUTTO
					V	OL/AD .J
				ENTE R
			M ENU		E XIT
				INP	UT
			ON/STA	NDBY
		TEMP					TEMP LAMP	ON
	BUS Y	LAM P	O N
		FAN
								Light (Orange)
							BUSY	FAN

The three indicators, TEMP, LAMP, and ON, light in green for several seconds and then the ON indicator lights in orange and the projector turns to the standby mode.

Do not perform any operations while the three indicators are lit green.

Power cord (Supplied)

4 Take off the lens cover.

Notes

•When the projector is moved from a cold location to a warm location, or when the ambient temperature in the projection room has risen suddenly, moisture may condense on the lens or the internal optical section to blur the projected pictures. In such a case, leave the projector for an adequate time (1 to 2 hours, depending on the room’s condition) before using it, so it adjusts to the ambient temperature.

•If the screen is exposed to direct sunlight or other strong light, the projected picture becomes too faint to see. Shut out the light with curtains or other means.

•If the screen and the projector are not installed properly, the projected picture may be distorted.