Toshiba TLP-MT7E manual Trouble indications, Indicator

64

Trouble indications

Maintenance

If there is some problem inside the projector, the indicators light up or blink.

Control panel

(Main unit side)

AUTO AUTO

KEYSTONE SET

VOL/ADJ.

ENTER EXIT

MENU INPUT

ON/STANDBY

TEMP LAMP ON

BUSY FAN

Indicator

TEMP LAMP	ON	The power does not come on.
BUSY	( off )	→ Malfunction of the unit.
	FAN

• Unplug the power cord and call the dealer.

Or (Lit in red)

TEMP LAMP	ON	The lamp turns off or does not light up.
(Lit in red) (Lit in red)		→ The projector will return to the standby mode in about 2 minutes. If the
		projector does not operate normally when the power is switched on again,
BUSY	FAN
		the lamp is at the end of its duration life or the unit has a fault.

•Lamp’s duration life is over, replace the lamp with a new one. 68

•Unplug the power cord and call the dealer.

The power turns off or does not come on.

TEMP LAMP	ON	→ The inside is too hot, or the projector has been working in an area of high
(Lit in red)
		temperature.
BUSY	FAN	• Place the projector correctly so the intake and exhaust fans’ holes are not covered.
(Lit in green or
		• Turn the projector off, and leave it for a while, and turn it on again.
	turns off)	• Clean the air filter. 65
Or
	Or
(Lit in red) (Lit in orange) (Lit in green)		* The icon	appears before the power turned off.

*The projector returns to the standby mode after the fault display has been shown for about 2 minutes.

TEMP LAMP		ON	The power turns off or does not come on.
		(Lit in red)	→ Trouble with the cooling fan.
BUSY		FAN	• Unplug the power cord and call the dealer.
(Lit or flashing	Or		* The icon	appears before the power turned off.
	(Lit or flashing		* The projector returns to the standby mode after the fault display has been
in red)	in orange)
			shown for about 2 minutes.
TEMP LAMP		ON	The power turns off or does not come on.
(Flashing in orange) (Lit in red)			→ The lamp cover is not properly attached.
BUSY		FAN	• Unplug the power cord and reattach the lamp cover. 69

*The icon appears before the power turned off.

*The projector returns to the standby mode after the fault display has been shown for about 2 minutes.

Notes

•If abnormality occurs while operating, unplug the power cord.

•When reinserting the power cord before the lamp has cooled, please wait until the lamp has cooled sufficiently before use. When the lamp is at a high temperature, it may not light and the duration life will be shortened.