Gigabit Uplink Web Smart Switch
Appendix A Troubleshooting
QQQQWhy does the Power LED work abnormally?
The Power LED should be lit up when the power system works normally. If the Power LED worked abnormally, please take the following steps:
111 Make sure that the power cable is connected properly, and the power contact is normal.
222 Make sure the voltage of the power supply meets the requirement of the input voltage of the Switch.
QQQQWhat could I do if I could not access the
You are recommended to check the following items:
111 Check every port LED on the Switch and make sure the cable is installed properly.
222 Try another port on the Switch and make sure the cable meets the requirement and works normally.
333 Turn off the power. After a while, turn on the power again.
444 Make sure the IP address of your PC is set within the subnet of the Switch.
555 If you still cannot access the configuration page, please restore the Switch to its factory defaults. Then the IP address should be set as 192.168.0.x ("x" is any number from 2 to 254\ and Subnet Mask as 255.255.255.0.
Troubleshooting 
50
