Configuration | Command Reference Listing |
Command Reference Listing
The complete command set reference is provided below. You can also view a complete listing of all CLI commands by typing help.
Command Syntax | Description |
|
antenna [hv] | Set or display antenna setting. H=Horizontal polarity, V=vertical |
|
| polarity. |
|
arq [onoff] | Enable or disable Auto Retransmit Request (ARQ). With ARQ |
|
| enabled, the |
|
| are detected as missing or corrupted. Default setting=ON. |
|
autorateshift [onoff] | Enable or disable automatic rate shift feature. With autorateshift |
|
| enabled, the radios will automatically renegotiate speed setting to |
|
| maximize wireless link integrity. Default setting=OFF. |
|
| Notes: |
|
| • Radio will start to perform diagnostic speed test |
|
| approximately 50 seconds after association. |
|
| • Radio will set new speed after finishing speed test. |
|
| • Radio will check link quality for increasing speed every 60 |
|
| seconds. |
|
| • Radio will check link quality for decreasing speed every 10 |
|
| seconds. |
|
| • Link quality is based on ARQ retransmit statistics and speed |
|
| assessment packets. |
|
| • Radio’s speed can be changed manually when auto rate shift |
|
| is on, however the speed will not be sustained. |
|
| • If auto rate shift is turned on after association, the radio will |
|
| not perform speed test. |
|
| • If auto rate shift is turned off after associated, radio will not |
|
| perform regular link quality assessment. |
|
|
|
|
autoscanmu [onoff] | Enable or disable auto scan MU (RU only). Default setting=OFF . | |
| When autoscanmu is turned on, the RU will automatically scan all |
|
| channels and polarizations searching for its peer MU. Once the RU |
|
| detects the MU it will stop scanning and lock onto the channel of the |
|
| MU. The autoscan feature is useful in cases where the user changes |
|
| the channel at the MU because the RU will automatically search for |
|
| the new channel of the MU. Note: |
|
| as 5 minutes. |
|
| Notes: |
|
| • RU will not perform auto scan during the first 60 sec after |
|
| opmode is turned on. |
|
| • RU will initiate auto scan cycle after losing sync for 10 |
|
| seconds. |
|
| • RU will scan all “available channels” and antenna |
|
| polarizations. |
|
| • After finishing scan cycle, RU will pick the best channel |
|
| and antenna by a) has sync and b) has highest packet rssi. |
|
| Afterwards RU will change to that channel with max power. |
|
| • If no channel is selected after finishing scan cycle, RU will |
|
| initiate auto scan cycle again after 10 seconds. |
|
|
|
|
|
|
|
Trango Broadband Wireless — | page 29 | |
