Getting Started System Information (sysinfo) Page
Trango Broadband Wireless — TrangoLINK-45 page 18
[S/N] Serial Number of Radio
[IP] User defined IP Address of radio
[Subnet Mask] User entered IP Subnet Mask
[Gateway] User entered IP address of the default router or gateway on the local
Ethernet segment
Section 2
[PoE Voltage] The voltage the ODU received from the Jbox.
[Radio Temp] The internal radio temperature in Celsius
[Opmode] Operation mode of the radio: ON = transmitting, OFF= not transmitting
[Default Opmode] Opmode which the radio defaults to after reboot.
[Active Channel] Active RF Chan nel and Antenna polarization
[Freq] Frequency of active channel
[Speed] Modulation Speed (6,12,18,24,36, 54 Mbps)
[Tx Power] Transmit Power
[Power Range] Allowable power range for chosen Frequency (dBm)
[Peer ID] MAC Address of remote radio
[Status] Connection status of remote radio (connected or disconnected)
[RSSI] Measured signal strength from remote radio (dBm)
[Peer IP Config] Remote radio’s IP subnet, and default Gateway configuration
[DFS Status] The current status of DFS.
Section 3
Channel Table: (MHz, n/a: not available in current area)
[Ch#01] 5265 dfs [Ch#02] 5285 dfs [Ch#03] 5305 dfs [Ch#04] 5325 dfs
[Ch#05] 5500 dfs [Ch#06] 5520 dfs [Ch#07] 5540 dfs [Ch#08] 5560 dfs
[Ch#09] 5580 dfs [Ch#10] 5600 dfs [Ch#11] 5620 dfs [Ch#12] 5640 dfs
[Ch#13] 5660 dfs [Ch#14] 5680 dfs [Ch#15] 5700 dfs [Ch#16] 5735
[Ch#17] 5755 [Ch#18] 5775 [Ch#19] 5795 [Ch#20] 5815
[Ch#21] 5835 [Ch#22] 5840 [Ch#23] 5840 [Ch#24] 5840
Section 4
[Area Code] Region (country code). Defines allowable frequencies. Area code is set by
the manufacturer and can not be altered by the user.
RF Band #1 (5180..5240 MHz) Disabled
RF Band #2 (5260..5325 MHz) [Power Range] -4..7/7/7/7 dBm
RF Band #3 (5480..5720 MHz) Disabled
RF Band #4 (5735..5835 MHz) [Power Range] -4..21/19/18/17 dBm
Section 5
[Tx MIR] Maximum Information Rate (Mbps). User may set Tx MIR in MU and RU
to different values.
[ARQ] Automatic Retransmit Request (On or Off)
[Encrypt] Encryption (On or Off)
[Key] Hexadecimal Encryption Key (must match in MU and RU)
[Auto Rate Shift] Automatic Rate Shift (adaptive modulation) (On or Off)
[Auto Scan MU] Auto Scan MU (RU setting only) (On or Off)
[RSSI LED] Enable or disable RSSI LEDs on bottom of radio. Disabling RSSI LEDs
improves system performance.