Tripp Lite owner manual B060-032 Front View

Introduction (continued)

B060-032 Front View

1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16
17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32	RESET	POWER	STATION ID

1

2

3 4 5

1.Firmware Upgrade Recovery Switch

During normal operation and while performing a firmware upgrade, this switch should be in the NORMAL position. If a firmware upgrade operation does not complete successfully, slide this switch to the RECOVER position and do a warm reset (see p. 31), to return the switch to its prior firmware state.

After returning the switch to its prior firmware state, slide the switch back to the NORMAL position to attempt the firmware upgrade again, or to use the switch with its prior firmware.

2.Port LEDs

The Port LEDs are multicolored (Red / Green / Amber), and provide status information about their corresponding CPU Ports as follows:

Color	Condition	Indication
Amber	Steady	Port is selected and the connected server is on.
	Flashing	Port is selected; Port is connected to a powered ON KVM switch
Red	Steady	Port is selected but connected server is OFF
Green	Steady	Port is not selected, the connected server is ON
	Flashing	Port is not selected: Port is connected to a powered ON KVM switch
Off		Port is not selected and the server is OFF

3.Reset Switch

Pressing this switch in performs a System Reset.

Note: This switch is semi-recessed and must be pushed with a thin object - such as the end of a paper clip, or a ballpoint pen.

4.Power LED

Lights to indicate that the B060-032 is powered up and ready to go.

5.Station ID LED

The B060-032’s Station ID is displayed here. If this is a Single Station installation (see p. 8), or the First Station on a Daisy Chained installation (see p. 10), the B060-032 has a Station ID of 01.

On a Daisy Chained installation, the B060-032 auto-senses its position and displays the Station ID that corresponds to its place in the chain. (see Port ID Numbering, p. 17 for details).

4