Diagnostics
E1:STALL | Incline not moving when commanded |
| to. |
E2:OVERSPEED | This error occurs when an acceleration |
| >2.1 mph occurs. Error cleared by |
| turning off power switch then turning |
| it back on. |
E2:CAL | Feedback cannot reduce or increase |
| speed to target. Error cleared by |
| calibrating. |
E3:RECAL | This error occurs when a data error is |
| detected on the EEprom, replace the |
| control panel. |
E5:SENSOR | This message is displayed when there |
| is no speed feedback. |
Diagnostics - Service Messages
The following service messages will be displayed as they occur, as well as for the subsequent six safety key insertions. These messages will be displayed until a key is pressed. Every time these messages are displayed, an audible will sound twice.
S1:LUBE This message is displayed when lubrication of the deck is recommended.
S2:CLEAN This message is displayed every 500 miles. Prompt to clean treadmill.
S3:MOTOR This message is displayed every 2500 hours. Prompt to check motor brushes.
37
