Tyco LPE-200 manual Exiting Data Calls, Scan Lockout Mode

EXITING DATA CALLS

Under normal conditions, the radio enters the scan lockout mode and returns to the control channel after completion of a data call (transmit or receive). If, during a data call, one of the following conditions occurs, the data call is immediately terminated and the radio per-forms the desired function:

•PTT activated.

•Emergency declared by pressing the pre- programmed emergency button.

•A group or system change.

SCAN LOCKOUT MODE

Following the transmission or reception of a data call, if scan is enabled, scanning will stop temporarily [two independent pre-programmed times (after receive data call and after transmit data call)]. During this time the scan indicator will flash to indicate that scan is enabled but temporarily suspended. This mode is normally exited when the pre-programmed time expires; however, the following actions will terminate the scan lockout mode before the timeout is completed.

•The CLEAR button is pressed.

•The PTT is pressed.

•A group or system change.

•Entering phone call mode.

80