Uniden BC125AT owner manual Adjusting the Belt Clip, Powering the Scanner

ADJUSTING the Belt Clip

The factory-attached belt clip makes it easier to carry the scanner. Use a Phillips screwdriver to adjust (loosen) the mounting screws or remove the belt clip completely.

POWERING THE SCANNER

You can power the scanner using alkaline (ALK) non- rechargeable batteries (not supplied) or the included Nickel Metal-Hydride (Ni-MH) rechargeable batteries. [Uniden provides a USB cable to charge the Ni-MH batteries on initial installation and to recharge them through your computer (or through a power adapter that provides USB charge power (not included, but available at many retailers).]

Inside the battery compartment is a switch to set the unit to either ALK or Ni-MH.

Warning! Non-rechargeable batteries can get hot or burst if you try to recharge them..

Cautions:

•When BATT flashes in the display and the scanner beeps every 15 seconds, recharge or replace the batteries.

•Use only fresh batteries of the required size and recommended type.

•Always remove old or weak batteries. Batteries can leak chemicals that destroy electronic circuits.

•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

22