Uniden BC246T owner manual Programming EDACS Systems, Programming Radio Systems

To program another channel within the same group, press Menu , then repeat the above.

To create another channel group and enter more channels, press Menu three times, then proceed from “Entering/Editing Motorola Channel Groups” on Page 56.

Programming EDACS Systems

Menu

Program SysteM E

New System E EDCS E

Next, rotate the scroll control to select the type of EDACS system you will program, then press E.

•WIDE - Use for wideband EDACS systems

•NARROW - Use for narrowband EDACS systems

•SCAT - Use for EDACS SCAT (Single Channel Autonomous Trunking)

When the scanner prompts Confirm?, press E to accept the settings. The scanner creates an empty EDACS

system, with a default name of System nnN E. nnN increments as you add new systems. The E indicates that this is an EDACS system.

Next, refer to the appropriate section to set system-wideoptions. For most settings, you can accept the default. However, for the items in bold, you must enter information in order for your scanner to scan the system.

•See “Editing the System Name” on Page 63

•See “Editing the System Quick Key” on Page 63

•See “Setting System Lockout” on Page 64

•See “Setting the System Hold Time” on Page 64

•See “Setting the Channel Delay Time” on Page 65

•See “Setting ID Scan/Search (Trunked Systems Only)” on Page 65

•See “Setting I-Call (Motorola and EDACS Systems Only)” on Page 68

•See “Setting Emergency Alert (Motorola and EDACS Systems Only)” on Page 69

Programming Radio Systems

58