Uniden BCD996T manual

BCD996T

Desk Surface

Bracket
Wood Screws	Mounting Feet (4)

To secure the radio, by means of the mounting bracket, to a surface, follow the steps below:

1.Attach the four protective rubber feet to the mounting bracket when you casually use the scanner on a flat surface. Should you desire to permanently mount the scanner, remove the feet and use wood screws through the bracket as described in Steps 2 and 3.

2.Use the bracket as a template to mark positions for the two mounting screws.

3.At the marked positions, drill holes slightly smaller than the screws.

4.Remove the paper backing from each washer and stick one inside of each bracket’s ear, aligning the washer’s hole with the bracket’s hole.

5.Align the bracket with the threaded holes on the sides of the radio case so the bracket is beneath the radio. Secure the bracket using the two threaded knobs. Never overtighten the knobs.

Once the radio is positioned, connect it to a source of AC power using the supplied 13.8V, 750 mA AC adapter. Insert the barrel of the AC adapter to the jack on the

rear, upper right side of the radio marked .

32