Select a site F

Edit Band Plan F

You can enter up to 3 band plans. Select the plan to enter or edit, then follow the prompts to enter the Base Frequency, Channel Step, and Channel Offset for the site.

Setting P25 Band Plans

(P25 Only)

The BCD996T includes two operation modes for P25 systems: explicit mode and implicit mode channel assignment. Explicit mode systems include all information needed to determine voice frequencies on the control channel. You must supply the system’s band plan for implicit systems for the scanner to correctly determine voice frequencies.

To set the band plan for a P25 system:

 

[MENU] Program System F

 

 

Edit Site F

 

 

Edit Band Plan F

 

Then, follow these steps:

 

1.

the Band Plan table entry you want to edit and

F.

2.

Enter the base frequency for the table entry and

F.

3.

Enter the spacing for the table entry (in kHz) and

F.

Repeat 1-3 for additional table entries.

Notes:

•For Explicit mode systems, leave all entries blank.

•There is no way to determine the correct entries using the scanner (other than trial and error). You must get this information from another source. Uniden America Corporation does not have this information.

Setting Control-Channel Only Mode

M (except for P25)

[MENU] Program System

F

 

Select a trunked system

F

 

Edit Site (current)

F

 

Select a non-P25 site

F

 

 

Set C-Ch Only F

 

 

 

Programming Your Scanner

81

Page 80 Page 82
Page 81
Image 81
Uniden BCD996T manual Setting P25 Band Plans P25 Only, Setting Control-Channel Only Mode Except for P25
Page 80 Page 82
Top Page Image Contents