Setting the toll saver switch | Uniden EXAI 7980 specification

Using the answering machine (continued)

Setting the toll saver switch

The ring time/tool saver switch sets your answering system to answer after two or four rings.

In the TS (toll saver) position, if you have new messages, the answering system answers after two rings. If there are no new messages, the system answers after four rings. This way, when you call long distance to check your messages, and have no messages, you can hang up after the second ring to save a charge.

RING TIME 2/4/TS

Setting maximum recording time for incoming messages

You can select the maximum recording time by sliding the REC TIME switch on the base unit to one of the following positions:

REC TIME ANN/4/1

1 : 1 minute

4 : 4 minutes

ANN : Announce only

Note

If you set the switch to ANN,

a prerecorded greeting plays, and no message will be accepted.

37

Image 37

Uniden EXAI 7980 owner manual Setting the toll saver switch, Setting maximum recording time for incoming messages

Contents

Exai Introduction Features Table of contents 6 to Read this first9 to10 11 to Step Checking the package contents Choose the best location Setting up the base unit Connect the base unit Tips Choose the dialing mode Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Setting Caller ID options Entering your area code On-hook dialing Making calls Off-hook dialing On-hook redialing RedialingOff-hook redialing Any key when ringing Auto Talk when ringingAny key when paging Receiving calls Handset ringer tone Handset ear speaker volume Base speaker volume Base ringer switchReceiving a call from the base Storing phone numbers and names Memory storing Dn »key to scroll through the characters Making calls with memory dialing Memory dialingOn-hook dialing Display a Programmed Number Off-hook dialing Editing a stored name and/or phone number Memory editing Use the #/ 1 and */tone/0 Erasing a stored name and/or phone number Memory erasing Caller ID Caller ID service Here are some typical displays When the telephone rings Viewing the Caller ID Message list Long Distance call settings and cancellation Deleting a Caller ID message Deleting information from the Caller ID list Deleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Setting the clock Using the answering machine Changing the greeting Recording the greeting Turning the answering machine on and off Setting the number of rings Setting maximum recording time for incoming messages Setting the toll saver switch Playing recorded messages Screening incoming calls Deleting recorded messages Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor When speaking on the base When speaking on the handsetAdditional information Way conversation Changing the digital security code Standard wall plate mounting Mounting the base unit on a wall Direct wall plate mounting Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure Symptom Suggestion Troubleshooting Additional information General SpecificationsBase unit Handset G, H IndexK, L W, X, Y, ZPage Uniden America Corporation