Mounting the base unit on a wall | Uniden EXAI 7980 specification

Align the mounting slots on the base. with the mounting posts on the wall. Push in and down until the phone is firmly seated.

Additional information (continued)

Mounting the base unit on a wall

[Standard wall plate mounting]

This phone can be mounted on any standard telephone wall plate.

1

2, 3, 4, 5, 6, 7

Wall plate

1 Snap the wall mount adapter into the notches on the base.

2 Plug the telephone line cord to the TEL LINE jack and the AC adapter to the DC IN 9V jack.

3 Plug the telephone line cord into the telephone outlet.

4 Wrap the AC adapter cord inside the molded wiring channel. Then wrap the cord around the strain relief notch.

5 Plug the AC adapter into a standard 120VAC wall outlet.

Note Use only the Uniden AC adapter supplied with this phone.

	6	Raise the antenna to a vertical
AC adapter		position.
AC outlet	7

47

Image 47

Uniden EXAI 7980 owner manual Mounting the base unit on a wall, Standard wall plate mounting

Contents

Exai Introduction Features Table of contents 11 to Read this first6 to 9 to10 Step Checking the package contents Choose the best location Setting up the base unit Connect the base unit Tips Choose the dialing mode Preparing the battery pack Cleaning the battery contacts Battery use time per chargeWhen the battery charge becomes low Setting Caller ID options Entering your area code On-hook dialing Making calls Off-hook dialing Off-hook redialing RedialingOn-hook redialing Receiving calls Auto Talk when ringingAny key when ringing Any key when paging Handset ringer tone Handset ear speaker volume Receiving a call from the base Base ringer switchBase speaker volume Storing phone numbers and names Memory storing Dn »key to scroll through the characters On-hook dialing Memory dialingMaking calls with memory dialing Display a Programmed Number Off-hook dialing Editing a stored name and/or phone number Memory editing Use the #/ 1 and */tone/0 Erasing a stored name and/or phone number Memory erasing Caller ID Caller ID service Here are some typical displays When the telephone rings Viewing the Caller ID Message list Long Distance call settings and cancellation Deleting a Caller ID message Deleting information from the Caller ID list Deleting all Caller ID name/numbers Long Distance calls Using the Caller ID listCalling a party from the Caller ID list Storing Caller ID messages in Memory Using Caller ID with call waiting service Setting the clock Using the answering machine Changing the greeting Recording the greeting Turning the answering machine on and off Setting the number of rings Setting maximum recording time for incoming messages Setting the toll saver switch Playing recorded messages Screening incoming calls Deleting recorded messages Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor Way conversation When speaking on the handsetWhen speaking on the base Additional information Changing the digital security code Standard wall plate mounting Mounting the base unit on a wall Direct wall plate mounting To attach the beltclip To remove the beltclip Installing the beltclipHeadset installation Power Failure MaintenanceBattery replacement and handling Symptom Suggestion Troubleshooting Additional information Handset SpecificationsGeneral Base unit W, X, Y, Z IndexG, H K, LPage Uniden America Corporation