Making calls, On-hook dialing | Uniden EXAI 7980 specs

Making calls

On-hook dialing

1

Dial the phone number.

(Phone numbers can be up to 32 digits.)

Example: Enter 817-858-3300

8178583300

		2 Press		talk	. “Talk” flashes on the
			display.
				Talk
			8178583300
		3 The number is dialed. After about 5
			seconds, the call-time display appears.
				Talk		0:00
			8178583300
*/tone/0	¥up
*/tone/0		4 Press
dn »	redial/p	4 Press		talk	or place the handset on
chan			the base to end the telephone call.
			The call-time will be displayed for
			about 5 seconds.
						5:15
Other Operations
To		Do this
To improve reception		Press	chan .
To adjust the ear speaker volume		Press	¥up	or	dn ».
To temporarily switch to tone dial (base		Press	*/tone/0 . The following numbers
must be set to pulse mode)		dialed will be sent as tone dialing.
To enter a pause within the numbers dialed		Press	redial/p .

Notes

•If there is no key entry for more than 20 seconds, on-hook dialing is cancelled and the telephone returns to the standby mode.

• The phone number can be edited before pressing talk .

13

Image 13

Uniden EXAI 7980 owner manual Making calls, On-hook dialing

Contents

Exai Introduction Features Table of contents 6 to Read this first9 to10 11 to Step Checking the package contents Choose the best location Setting up the base unit Connect the base unit Tips Choose the dialing mode Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Setting Caller ID options Entering your area code On-hook dialing Making calls Off-hook dialing On-hook redialing RedialingOff-hook redialing Any key when ringing Auto Talk when ringingAny key when paging Receiving calls Handset ringer tone Handset ear speaker volume Base speaker volume Base ringer switchReceiving a call from the base Storing phone numbers and names Memory storing Dn »key to scroll through the characters Making calls with memory dialing Memory dialingOn-hook dialing Display a Programmed Number Off-hook dialing Editing a stored name and/or phone number Memory editing Use the #/ 1 and */tone/0 Erasing a stored name and/or phone number Memory erasing Caller ID Caller ID service Here are some typical displays When the telephone rings Viewing the Caller ID Message list Long Distance call settings and cancellation Deleting a Caller ID message Deleting information from the Caller ID list Deleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Setting the clock Using the answering machine Changing the greeting Recording the greeting Turning the answering machine on and off Setting the number of rings Setting maximum recording time for incoming messages Setting the toll saver switch Playing recorded messages Screening incoming calls Deleting recorded messages Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor When speaking on the base When speaking on the handsetAdditional information Way conversation Changing the digital security code Standard wall plate mounting Mounting the base unit on a wall Direct wall plate mounting Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure Symptom Suggestion Troubleshooting Additional information General SpecificationsBase unit Handset G, H IndexK, L W, X, Y, ZPage Uniden America Corporation