Changing the digital security code | Uniden EXAI 7980 instruction

Additional information (continued)

Changing the digital security code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary.

The first time you charge your handset, the security code is automatically set. (See page 4.)

In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1 Place the handset on the base unit. Press page .

The handset beeps.

2 Remove the handset from the base unit.

3 Place the handset on the base unit. Leave the handset on the base for at least 3 seconds. A new random security code is set.

Note

If the handset battery pack is completely discharged or the battery pack removed, the digital security code will be lost. If this happens, a new security code is set automatically the next time the battery pack is charged.

46

Image 46

Uniden EXAI 7980 owner manual Changing the digital security code

Contents

Exai Features Introduction Table of contents 9 to10 Read this first6 to 11 to Checking the package contents Step Setting up the base unit Choose the best location Connect the base unit Choose the dialing mode Tips Preparing the battery pack When the battery charge becomes low Battery use time per chargeCleaning the battery contacts Setting Caller ID options Entering your area code Making calls On-hook dialing Off-hook dialing On-hook redialing RedialingOff-hook redialing Any key when paging Auto Talk when ringingAny key when ringing Receiving calls Handset ear speaker volume Handset ringer tone Base speaker volume Base ringer switchReceiving a call from the base Memory storing Storing phone numbers and names Dn »key to scroll through the characters Making calls with memory dialing Memory dialingOn-hook dialing Off-hook dialing Display a Programmed Number Memory editing Editing a stored name and/or phone number Use the #/ 1 and */tone/0 Memory erasing Erasing a stored name and/or phone number Caller ID service Caller ID When the telephone rings Here are some typical displays Long Distance call settings and cancellation Viewing the Caller ID Message list Deleting information from the Caller ID list Deleting a Caller ID message Deleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Using the answering machine Setting the clock Recording the greeting Changing the greeting Setting the number of rings Turning the answering machine on and off Setting the toll saver switch Setting maximum recording time for incoming messages Playing recorded messages Deleting recorded messages Screening incoming calls Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor Additional information When speaking on the handsetWhen speaking on the base Way conversation Changing the digital security code Mounting the base unit on a wall Standard wall plate mounting Direct wall plate mounting Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure Troubleshooting Symptom Suggestion Additional information Base unit SpecificationsGeneral Handset K, L IndexG, H W, X, Y, ZPage Uniden America Corporation