Direct wall plate mounting | Uniden EXAI 7980 specs

Additional information (continued)

8 On the base unit, pull the handset

Handset retainer

retainer out of the slot. Rotate it clock- wise 180 degrees.

9 Flip the retainer from front to back. Slide it back into the slot so that the lip of the retainer is up and the oval is down. The retainer holds the handset in place,

[Direct wall plate mounting]

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location. That could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 10 - 15 feet of a working phone jack to avoid excessive cord lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

TOP

3/16 in.

3-15/16 in.

1 Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 3/16 of an inch between the wall and screwheads for mounting the phone.

2 Refer to steps 1 through 8 on page 47 to mount the telephone.

48

Image 48

Uniden EXAI 7980 owner manual Direct wall plate mounting

Contents

Exai Features Introduction Table of contents Read this first 6 to9 to10 11 to Checking the package contents Step Setting up the base unit Choose the best location Connect the base unit Choose the dialing mode Tips Preparing the battery pack Battery use time per charge When the battery charge becomes lowCleaning the battery contacts Setting Caller ID options Entering your area code Making calls On-hook dialing Off-hook dialing Redialing On-hook redialingOff-hook redialing Auto Talk when ringing Any key when ringingAny key when paging Receiving calls Handset ear speaker volume Handset ringer tone Base ringer switch Base speaker volumeReceiving a call from the base Memory storing Storing phone numbers and names Dn »key to scroll through the characters Memory dialing Making calls with memory dialingOn-hook dialing Off-hook dialing Display a Programmed Number Memory editing Editing a stored name and/or phone number Use the #/ 1 and */tone/0 Memory erasing Erasing a stored name and/or phone number Caller ID service Caller ID When the telephone rings Here are some typical displays Long Distance call settings and cancellation Viewing the Caller ID Message list Deleting information from the Caller ID list Deleting a Caller ID message Deleting all Caller ID name/numbers Using the Caller ID list Calling a party from the Caller ID listLong Distance calls Storing Caller ID messages in Memory Using Caller ID with call waiting service Using the answering machine Setting the clock Recording the greeting Changing the greeting Setting the number of rings Turning the answering machine on and off Setting the toll saver switch Setting maximum recording time for incoming messages Playing recorded messages Deleting recorded messages Screening incoming calls Leaving a voice memo Recording a phone conversation 2-way REC Selecting a PIN code Remote access Remote room monitor When speaking on the handset When speaking on the baseAdditional information Way conversation Changing the digital security code Mounting the base unit on a wall Standard wall plate mounting Direct wall plate mounting Installing the beltclip Headset installationTo attach the beltclip To remove the beltclip Maintenance Battery replacement and handlingPower Failure Troubleshooting Symptom Suggestion Additional information Specifications GeneralBase unit Handset Index G, HK, L W, X, Y, ZPage Uniden America Corporation