AMX NXD-700Vi manual Flat installation surface

Installation

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

6.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify that the panel is receiving power and functioning properly before finalizing the installation.

Flat installation surface

Install the four #4-40 Mounting Screws (included) into these four holes

Mounting Tab

Attachment is done along the edges of the cutout

		B - Main NXD-700Vi unit
FIG. 16		Wall Mount panel installation configuration for flat surfaces
7.	Disconnect the terminal end of the power cable from the power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before being inserted into the solid surface.

8.Carefully slide the main unit into the cutout until the Mounting Tabs of the NXD-700Vi unit lie flush against the wall.

9.Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes located along the sides of the NXD-700Vi (using a grounded Phillips-head screwdriver) until the unit is secure and flush against the wall (FIG. 16).

10.Place the Faceplate/Trim Ring assembly (A in FIG. 16) back onto the main unit (B in FIG. 16). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

11.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

12.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

22 7" Modero Widescreen Touch Panels