AMX NXD-700Vi manual Close and Resecure the NXD Panel Enclosure

Installation and Upgrade of the Internal NXD Components

6.To complete the upgrade process, either upgrade the remaining wireless card (Step 3) or close and re-secure the enclosure using the procedures in Step 3: Close and Resecure the NXD Panel Enclosure section on page 11.

Card removal grooves

On-board Compact

Flash connector (with pins)

Insert with arrow facing towards the pins

Connector opening

FIG. 6 Removing/installing a Compact Flash Memory card

Any new internal card upgrade is detected by the panel only after power is cycled.

Step 3: Close and Resecure the NXD Panel Enclosure

1.Gently place the outer housing back onto the panel and align the four pan-head Housing Screws holes along the edges of the outer housing.

2.Insert and secure the four pan-head Housing Screws back into their pre-drilled holes by using a grounded Phillips-head screwdriver.

3.Slip the connector overlay back into the connector opening by inserting the top of the overlay into the connector opening in an upwards direction.

4.Align the connectors to their respective locations and secure the overlay by pushing it towards the connectors until the overlay securely snaps back into the overlay release latches.

5.Re-install the faceplate back onto the panel. Refer to the Installing the Button Trim Ring section on page 14 for more detailed faceplate installation information.

7" Modero Widescreen Touch Panels 11