AMX NXD-700Vi manual Access Point MAC, Address, Network Name Ssid WAP names, Wireless Security

Firmware Pages and Descriptions

Wireless Settings Page (Cont.)

IP Settings:	Sets the IP communication values for the panel:
DHCP/STATIC	Sets the panel to either DHCP or Static communication modes.
	• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
	server.
	• Static IP is a permanent IP Address assigned to the panel. If Static IP is
	selected, the other IP Settings fields are enabled (below).
IP Address	Enter the secondary IP address for this panel.
Subnet Mask	Enter the subnetwork address for this panel.
Gateway	Enter the gateway address for this panel.
Host Name	Enter the host name for this panel.
Primary DNS	Enter the address of the primary DNS server used by this panel for host name
	lookups.
Secondary DNS	Enter the secondary DNS address for this panel.
Domain	Enter a unique name to the panel for DNS look-up.
MAC Address	This unique address identifies the wireless Ethernet card in the panel (read-
	only).
Access Point MAC	This unique address identifies the Wireless Access Point (WAP) used by this
Address:	panel for wireless communication (read-only).
	• Site Survey button: Launches the Site Survey page. The options on this page
	allow you to detect (“sniff-out”) all WAPs transmitting within range of the
	panel’s NXA-WC80211GCFWi-Fi card.
	Data displayed on the Site Survey page is categorized by:
	- Network Name (SSID) - WAP names
	- Channel (RF) - channels currently being used by the WAP
	- Security Type - security protocol enabled on the WAP, if detectable
	- Signal Strength - None, Poor, Fair, Good, Very Good, and Excellent
	- MAC Address - Unique identification of the transmitting Access Point
	• Refer to the Using the Site Survey tool section on page 34 for more detailed
	information on the SIte Survey page.
	• When communicating with a NXA- WAP200G, enter the MAC Address
	(BSSID) of the target WAP as the Access Point MAC Address. Refer to the
	WAP200G Instruction Manual for more information.
Wireless Security:	Sets the wireless security method to be used by the panel to connect to the net-
	work. Selecting any of the connection method buttons invokes the relevant con-
	figuration page, with options that allow you to define parameters specific to the
	selected method of connection.
	• Refer to the following Wireless Security Page section on page 82 for further
	details on these security options.
Open (Clear Text)	This button opens the Open (Clear Text) Settings page (FIG. 67 on page 83).
	“Open” security does not utilize any encryption methodology, but requires an
	SSID (alpha-numeric) entry. This entry must match the Network Name (SSID)
	entry of the target WAP so the panel knows what device it is using to communi-
	cate with the network.
	• Refer to the following Wireless Security Page section on page 82 for further
	details on these security options.
Static WEP	This button opens the Static WEP Settings page (FIG. 68 on page 84).
	“Static WEP” security requires that both a target WAP be identified and an
	encryption method be implemented prior to establishing communication.
	• Refer to the Wireless Security Page section on page 82 for further details on
	these security options.

80 7" Modero Widescreen Touch Panels